Troubleshoot A hardware of a Computer System.
step’s on how to troubleshoot your computer hardware ,Note that the step’s are
further broken down into the simplest form , that even A primary school student
can understand it in step by step way, So kindly follow the step’s(from 1 -10)
gradually carefully, hope you gain from it….
to always visit our site
Alitech(alitechzy.tk) for more related post ,let go but before that you
may Also like to know Step By step ways on how to Troubleshoot the IDE on a computer
about some days back …
The Mother Board.
desktop /tower computer system
fault hardware components (defective mouse, defective DIMM module, defective
FDD cable ,defective power connector)
familiarize you with some of the error associated with bad devices. You will
receive different messages from the computer depending on which device has a
problem .You will explore a fault with IDE connectivity various no –signal
setting in the cmos setup
(a) Verify that the PC is off; if it is not, shut it down.
back of the PC as shown in Figure 4-1
given in Table4-1
(f) Plug in the keyboard .
Figure 4-2: Unplug
the PC as shown in Figure 4-2
your observation in Table 4-2
is selected from the Start button
off the PC
browse to L2 Cache, usually in Advance
NOTE: the L2 Cache is sometimes
called the External Cache
pressing the +/- key or by pressing ENTER
and using the arrow keys
CMOS Setup as before
time, Enable L2 Cache
slot, either a PCI or AGP slot as shown in Figure 4-3
you observation in Table 4-4
Figure 4-3: Unplug
the Video Card .
motherboard. Be careful with the clamps on the ends of the memory slot as shown
in Figure 4-4
your observation in Table 4-5
interface at the end connected to the floppy drive as shown in Figure 4-5
Figure 4-5: Unplug
to it’s original location
8. Cd -rom power
as in Figure 4-6. Don’t unplug the interface cable
same cable, record the error of the non-booting system in Table 4-8. Skip to
move the mouse and double-click on My
the right in Table 4-9
clicking the X in the top right part of the Window.
(g) Shut down Windows by
clicking Start/Shut Down and Turn Off.
(h) Put off the PC and replace
the CD-ROM power connector into it’s original location
to the HDD as in Figure 4-7.
your observation in Table 4-10
the HDD power connector
Figure 4-7: Hard
the HDD as in Figure 4-8
your observation in Table 4-11
the motherboard power connector
much to us .
these post with your friends by using the comment box ,we remain loyal Alitech